Saving and Restoring the Software Settings

Use this option to save your configuration to a USB stick or restore a previously saved file:

1. Insert a memory stick into the USB 2.0 (A) connector. See table in Main Station/Remote Station: Front panel

2. In Menu mode, select Administration and then Settings.

3. To save, in the third menu, select Save All. Once you select Save you should not remove the USB stick right away. Depending on the USB stick it might take up to 5 seconds to complete.

4. To restore all HMS settings, in the third menu, select Restore all.

   1. In the fourth menu, select a file from USB.

   2. This restores the Helixnet Base, the Role and the Channel settings from the USB stick to your system.

5. To restore Roles and Channel names only, in the third menu, select Restore Role/Ch.

   1. In the fourth menu, select a file from USB.

   2. This restores Role and Channel settings from the USB to your system. Network settings are NOT restored.

Type of Save	Result
Save All	Saves your whole configuration; Main Station, Remote Stations, Speaker Stations, Roles/Channel names  to the USB for future use. This option also saves 2-wire and 4-wire port settings and assignment.
Restore All	Restores all settings from the file stored on the USB.
Restore Role/Ch	Restores Channel names and Role configuration only from the file stored on the USB. Network settings (including Linking and Expansion) are NOT saved.